RIDGID WD19560 Bedienungshandbuch PDF herunterladen (Seite 12)

Operation (continued)

1. The Vac comes equipped with a drain

for easy emptying of liquids. Simply

unscrew the drain cap and lift the

opposite side slightly to empty the

drum.

2. Another option is to remove the

powerhead assembly and dump the

drum contents into the proper waste

disposal container.

WARNING: To reduce the risk of

back injury or falls, do not lift a Vac

heavy with liquid or debris. Scoop

or drain enough contents out to

make the Vac light enough to lift

comfortably.

Emptying the Drum

N

OTE:

A

dry filter is necessary to pick up

dry material. If you use your Vac to pick

up dust when the filter is wet, the filter will

clog quickly and be very difficult to clean.

Allow filter to dry out before storing.

Vacuuming Liquids

1. When picking up small amounts of

liquid the filter may be left in place.

2. When picking up large amounts of

liquid we recommend that the filter be

removed. If the filter is not removed, it

will become saturated and misting may

appear in the exhaust.

3. When the liquid in the drum reaches a

predetermined level, the float

mechanism will rise automatically to cut

off air-flow. When this happens, turn off

the Vac, unplug the power cord, and

empty the drum. You will know that the

float has risen because Vac airflow

ceases and the motor noise will become

higher in pitch, due to increased motor

speed.

4. After using the Vac to pick up liquids, the

filter must be dried to reduce the risk of

possible mildew and damage to the filter.

IMPORTANT: To reduce the risk of

damage to the Vac do not run motor with

float in raised position.

Moving the Wet/Dry Vac

Should it become necessary to pick the

Vac up to move it, the handle on the

sides of the dust drum are used to lift. To

maneuver the Vac, the metal handle in

the rear of the unit should be used.

Blowing Feature

Your Vac features a blowing port. It can

blow sawdust and other debris. Follow

the steps below to use your Vac as a

blower.

WARNING: Always wear safety

eyewear complying with ANSI Z87.1

(or in Canada, CSA Z94.3) before

using as a blower.

CAUTION: Wear a dust mask if

blowing creates dust which might

be inhaled.

CAUTION: To reduce the risk of

hearing damage, wear ear protectors

when using the Vac/blower for

extended time or in a noisy area.

WARNING: To reduce the risk of

injury to bystanders, keep them

clear of blowing debris.

!

!

!

!

!

12

SP6731 16 Gallon 10/23/09 11:08 AM Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare