RIDGID WD19560 Bedienungshandbuch PDF herunterladen (Seite 14)

14

Maintenance

Push/Pull Handle

Cord Wrap

Power

Cord

Filter Cleaning

Your filter should be cleaned often to

maintain peak Vac performance.

Be sure to dry the filter before storing or

picking up dry debris.

IMPORTANT: After cleaning, check the

filter for tears or small holes. Do not use

a filter with holes or tears in it. Even a

small hole can cause a lot of dust to

come out of your Vac. If your filter is

damaged or worn, replace it immediately

.

Filter Removal

Refer to section “Filter Removal and

Installation” of this manual.

WARNING: To reduce the risk of

injury from accidental starting,

unplug power cord before changing

or cleaning filter.

NOTE:

The filter is made of high quality

paper designed to stop very small

particles of dust. The filter can be used

for dry pick up or small amounts of liquid.

Handle the filter carefully when removing

to clean or installing it. Creases in the

filter pleats may occur from installation

but will not affect the performance of the

filter.

Filter

Cord Wrap

W

hen vacuuming is complete, unplug the

cord and wrap it around the power

assembly as shown. The cord should wrap

under the pull handle (above the inlet) and

around and under the cord wrap of the

motor cover.

IMPORTANT: To avoid damage to the

blower wheel and motor, always reinstall

the filter before using the Vac for dry

material pick-up.

Cleaning A Dry Filter

1. Some removal of dry debris can be

accomplished without removing the

filter from the Vac. Slap your hand on

top of the lid while the Vac is turned

off.

2. For best cleaning results due to

accumulated dust, clean the filter in an

open area. Cleaning SHOULD be

done outdoors and not in the living

quarters.

3. After filter removal from Vac, remove

the dry debris by gently tapping filter

against the inside wall of your dust

drum. The debris will loosen and fall.

4. For thorough cleaning of dry filter with

fine dust (no debris), run water

through it as described under

"Cleaning A Wet Filter"

W

ARNING:

Do not operate

without filter cage and float, as they

prevent liquid from entering the

impeller and damaging the motor

.

!

!

Cleaning A Wet Filter

After filter is removed, run water through

the filter from a hose or spigot. T

ake care

that water pressure from the hose is not

strong enough to damage filter

.

Installation

Refer to section “Filter Removal and

Installation” of this manual.

Allow the filter to dry before reinstalling

and storing the Vac.

SP6731 16 Gallon 10/23/09 11:08 AM Page 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare