RIDGID WD19560 Bedienungshandbuch PDF herunterladen (Seite 10)

10

Wet/Dry Vac Assembly

1. Position the powerhead assembly on

the drum/caddy assembly as shown

(assembled earlier).

2. Rotate both latches down and press

until you hear them snap over the

flanges on the drum.

Latch

Drum

Latch

Handles

Drum

Drum

Latch

Insert Hose

Insert the push button end of the “Tug-A-

Long” hose into the inlet of the Vac. The

hose should snap into place. To remove

the hose from the Vac, press the release

button in the hose assembly and pull the

hose out of the Vac inlet, as shown.

Release

Button

Press

and

Pull

7. Insert the caster stem into the socket of

the caster foot as shown. (Front

casters only).

8. Push on the caster until the ball on the

caster stem is inserted all the way into

the socket. You will be able to hear the

ball snap into the socket and the caster

will swivel easily when positioning is

correct.

9. Rotate drum/caddy assembly upright,

using a long phillips screwdriver, install

(8) #10 x 3/4” screws into matching

holes on both right and left side of

caddy. Tighten screws until just snug.

Do not over tighten as this may tend to

deform the caddies.

L

E

F

T

Socket

Caster Stem

Caster Ball

#10 x 3/4"

Screw (8)

Drum/Caddy Assembly (continued)

SP6731 16 Gallon 10/23/09 11:08 AM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare