RIDGID TS3650 Betreibershandbuch PDF herunterladen (Seite 47)

ADJUSTMENTS

bLaDE

RIP FENCE

LOCKING

HaNDLE

SCREWS

LOCK

Nut

KNOb

MItER

GauGE baSE

45° aDJuStabLE

StOP SCREW

0° aDJuStabLE

StOP SCREW

MItER

GauGE ROD

TO ADJUST THE MITER GAUGE

See Figure 75.

You can set the miter gauge at 0° and plus or minus 45°

with the miter gauge stop pin and adjustable stop screws.

NOTE: The miter gauge provides close accuracy in

angled cuts. For very close tolerances, test cuts are

recommended.

 Loosen knob and pull out on stop pin to rotate miter

gauge base past stop screws.

 Loosen the lock nut of the 0° stop screw at the stop pin

with a 8 mm wrench.

 Place a 90° square against the miter gauge rod and the

miter gauge base.

 If the rod is not square, loosen the knob, adjust the rod,

and tighten the knob.

 Adjust the 0° stop screw until it rests against the stop

pin.

 Adjust the plus and minus 45° stop screws using a 45°

triangle and the steps above.

TO CHECK THE ALIGNMENT OF THE RIP

FENCE TO THE BLADE

See Figure 76.

WARNING:

To reduce the risk of injury, always make sure the

rip fence is parallel to the blade before beginning

any operation.

 Unplug the saw.

 Raise the locking handle to permit the rip fence to be

moved.

 Place a framing square beside the blade and move the

rip fence up to the square. Take the dimension on the rip

scale.

 Move the fence back and turn the framing square 180°

to check the other side.

 If the two dimensions are not the same, loosen the

4 screws on the fence and align it.

 Retighten the 4 screws.

 Make two or three test cuts on scrap wood. If the cuts

are not true, repeat the process.

NOTE: The rip fence must be secure when the locking handle

is engaged. The clamp screw on the rear of the rip fence is

tightened by turning clockwise to increase tightness of the

rear of the rip fence. Adjust if needed.

FRaMING

SQuaRE

Fig. 75

Fig. 76

StOP

SCREWS

CLaMP

SCREW

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53 54

Kommentare zu diesen Handbüchern

Keine Kommentare

RIDGID TS3650 Betreibershandbuch Seite 47

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kreissägen RIDGID TS3650