RIDGID TS3650 Betreibershandbuch PDF herunterladen (Seite 23)

ASSEMBLY

INSTALLING/REMOVING THE THROAT PLATE

See Figure 25.

 To install the throat plate, slip the tab underneath the saw

table at the back of the saw and push down to secure in

place.

 To remove the throat plate, place your index finger in

the hole and lift the front end, pulling the throat plate out

toward the front of the saw.

ASSEMBLING THE RAILS

See Figures 26 - 28.

To assemble the front rail:

NOTE: Do not completely tighten set screws until all front

rail pieces are assembled and you have made sure the rail

will lie flat and level.

NOTE: Front rail sections have a rip scale printed on them.

In the illustrations, rail connector bars are inserted into the

long rail section first.

Insert half of each rail connector bar into the grooves in

the rail sections.

Using a 3 mm hex key, attach the connector bar to the

rail by partially tightening the set screws.

Attach a second rail connector bar in the same way as

the first one.

NOTE: The left side rail section is shorter than the right side.

Slide the second front rail section onto the first, over the

attached rail connector bars. Partially tighten set screws.

Place the assembled rail sections on a flat surface and

make sure the rail lies flat and level. There should be no

gaps between the two sections.

Securely tighten all set screws.

To assemble the rear rail:

Slide the remaining rail connector bar into the slot in the

a rear rail section.

Assemble the rear rail sections in the same way as the

front rail. Make sure the rail lies flat and level and there

are no gaps between the two sections.

Securely tighten all set screws.

raIl

cONNectOr

bar

raIl cONNectOr

bar

frONt raIl assembly

heX Key

set screws

Fig. 26

rIP scale

lONG raIl

sectION

shOrt raIl sectION

blaDe thrOat

Plate

Fig. 27

frONt raIl

sectIONs

raIl cONNectOr

bar

Fig. 28

rear raIl assembly

rear raIl

sectIONs

raIl cONNectOr

bar

Fig. 25

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 53 54

Kommentare zu diesen Handbüchern

Keine Kommentare

RIDGID TS3650 Betreibershandbuch Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kreissägen RIDGID TS3650