RIDGID R4120 Betreibershandbuch PDF herunterladen (Seite 31)

Fig. 36

RIGHT

OPERATION

CUTTING WARPED MATERIAL

See Figures 35 - 36.

When cutting warped material, always make sure it is posi-

tioned on the miter table with the convex side against the

fence as shown in ﬁgure 36.

If the warped material is positioned the wrong way as shown

in ﬁgure 35, it will pinch the blade near the completion of

the cut.

WARNING:

To avoid a kickback and to avoid serious personal

injury, never position the concave edge of bowed

or warped material against the fence.

Bevel

Angle Type of Cut

Setting

Left side, inside corner

1. Top edge of molding against fence

2. Miter table set right 45°

3. Save left end of cut

Right side, inside corner

1. Bottom edge of molding against fence

2. Miter table set left 45°

3. Save left end of cut

Left side, outside corner

1. Bottom edge of molding against fence

2. Miter table set left 45°

3. Save right end of cut

Right side, outside corner

1. Top edge of molding against fence

2. Miter table set right 45°

3. Save right end of cut

0°

WRONG

Fig. 35

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

RIDGID R4120 Betreibershandbuch Seite 31