RIDGID WD1665 Bedienungshandbuch PDF herunterladen (Seite 12)

Blower Intake

After using the detachable blower of your

Wet/Dry Vac, examine the bottom of the

blower for dust and debris. Check to see

if the intake to the blower has debris

stuck to the plastic vents and foam pad.

To clean the foam pad under the intake

shield of the detachable blower:

1. Remove the three screws holding the

intake shield.

2. Lift the intake shield off and set aside.

3. Lift the foam pad away from the

detached blower, the foam pad holder

will also lift away from the blower.

4. Remove the foam pad from pad holder

and set the foam pad holder to the

side. Clean the foam pad in warm

soapy water or brush debris away.

Allow foam pad to dry.

Maintenance

WARNING: To reduce the risk of

injury from accidental starting,

unplug power cord before changing

or cleaning filter or foam pad.

Foam Pad

Holder

Foam Pad

Intake Shield

Screws (3)

5. Examine foam pad f

or reuse

.

If y

ou

need to replace it, check the service

part section of this manual.

6. Replace foam pad holder on blower

w

ith the tabs away from the blower.

Reinstall foam pad under the tabs of

the holder.

7. Reinstall intake shield and 3 screws.

The unit is ready for use.

Filter

NOTE: The filter is made of high quality

paper designed to stop very small

particles of dust. The filter can be used

for dry debris or small amounts of liquid.

Handle the filter carefully when removing

to clean or installing it. Creases in the

filter pleats may occur from installation

but will not affect the performance of the

filter.

Filter Cleaning

Your filter should be cleaned often to

maintain peak Vac performance.

Be sure to dry the filter before storing or

picking up dry debris.

IMPORTANT: After cleaning, check the

filter for tears or small holes. Do not use a

filter with holes or tears in it. Even a small

hole may allow a lot of dust to come out

of the exhaust port of your Vac. Replace it

immediately.

Filter Remo

val

Refer to page 5 "Filter Removal and

Installation" Section of this manual.

IMPORTANT: To avoid damage to the

blower wheel and motor, always reinstall

the filter before using the Vac for dry

material pic

kup.

!

12

SP6728-1 16 Gallon 3/19/10 10:58 AM Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare