RIDGID WD1665 Bedienungshandbuch PDF herunterladen (Seite 10)

10

Operation (continued)

Vacuuming Dry Materials

1. The filter must always be in correct

position at all times to avoid leaks and

possible damage to Vac.

2. When using your Vac to pick up very

fine dust, it will be necessary for you to

empty the drum and clean the filter at

more frequent intervals to maintain

peak Vac performance.

NOTE: A dry filter is necessary to pick up

dry material. If you use your Vac to pick

up material when the filter is wet, the filter

will clog quickly and be very difficult to

clean.

Vacuuming Liquids

1. When picking up small amounts of

liquid the filter may be left in place.

2. When picking up large amounts of

liquid we recommend that the filter be

removed. If the filter is not removed, it

will become saturated and misting may

appear in the exhaust.

3. When the liquid in the drum reaches a

predetermined level, the float

mechanism will rise automatically to cut

off air-flow. You will know that the float

has risen because Vac airflow ceases

and the motor noise will become higher

in pitch, due to increased motor speed.

When this happens, turn off the Vac,

unplug the power cord, and empty the

drum.

4. After using the Vac to pick up liquids, the

filter must be dried to avoid possible

mildew and damage to the filter.

IMPORTANT: To reduce the risk of

damage to the Vac, do not run motor with

float in raised position.

WARNING:To reduce the risk of

injury from accidental starting,

unplug power cord before emptying

the drum.

WARNING:To reduce the risk of

back injury or falls, do not lift a Vac

heavy with liquid or debris. Scoop

or drain enough contents out to

make the Vac light enough to lift

comfortably.

Emptying the Drum

3. Dump the drum contents into the proper

waste disposal container.

4. If the contents are liquid, you may

dispose by using the drain provided in

the drum for easy emptying. Simply

unscrew the drain cap and allow the

liquid to drain completely out of the Vac

drum.

Moving the Wet/Dry Vac

Should it become necessary to pick the

Vac up to move it, the handles on the

sides of the dust drum are used to lift. To

maneuver the Vac, the pull handle above

the inlet should be used.

Blowing Feature

Your Wet/Dry Vac has a “detachable

blower”. It has the capability to be used

as a dedicated blower for yard work,

patio cleanup and workshop applications

to blow sawdust and other debris.

W

ARNING: Always wear safety

eyewear complying with ANSI Z87.1

(or in Canada, CSA Z94.3) before

using as a b

lower.

WARNING: Do not operate

without filter cage and float, as they

prevent liquid from entering the

impeller and damaging the motor.

Drum

Latch

1. To remove the lid to empty contents of

the dust drum simply lift the two drum

latches at the front and rear of the dust

drum and lift the lid assembly up and

off the dust drum and set to the side.

2. Lay the lid assembly upside down on a

clean area while emptying drum or

changing the filter.

!

!

!

!

SP6728-1 16 Gallon 3/19/10 2:56 PM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare