RIDGID R138BNA Betreibershandbuch

1Your brad nailer has been engineered and manufactured to our high standards for dependability, ease of operation, and operator safety. When properly

10OPERATIONDANGER:Do not use oxygen, combustible gases or bottled gases as a power source for this tool. The tool will explode and cause death or seri

11OPERATIONNO-MAR PAD See Figure 2.The no-mar pad attached to the nose of the tool helps prevent marring and denting when working with

12OPERATIONWARNING:Disconnect the tool from the air supply before leaving the work area, moving the tool to another location, or handing the

13OPERATIONLOADING THE TOOL WITH NAILSSee Figure 5.Connect the tool to the air supply.WARNING:The tool’s driving mechanism may cycle when the tool

14OPERATIONFig. 6seleCTor in posiTion BseleCTorin posiTion aTrigger leVer piVoT pin(depress To alloW seleCTor To roTaTe)WARNING:During normal use the

15OPERATIONSETTING THE AIR PRESSURE The amount of air pressure required will depend on the size of the nail and the workpiece material. Begin testing

16OPERATIONCLEARING A JAMMED FASTENERSee Figure 10.WARNING:Disconnect the tool from the air supply before clearing a jammed fastener. Failure t

17MAINTENANCEWARNING: When servicing use only identical RIDGID® replacement parts. Use of any other parts may create a hazard or cause pr

18REQUIRED DAILY CHECKLISTSee Figures 11 - 12.Disconnect the air supply from the tool and remove all fasteners.Check all screws, nuts, bolts, and

19TROUBLESHOOTINGAir leak near the top of the tool or in the trigger areaPROBLEM POSSIBLE CAUSE SOLUTIONLoose screwsWorn or damaged O-rings or

2Introduction...

20NOTES

21WARRANTYProof of purchase must be presented when requesting warranty service. This product is manufactured by One World Technologies, Inc. The trade

22987000-322 05-19-08 (REV:01)Customer Service Information:For parts or service, contact your nearest RIDGID authorized service center. Be sure to

3GENERAL SAFETY RULESDANGER:READ AND UNDERSTAND TOOL LABELS AND MANUAL. Failure to follow warnings could result in DEATH or SERIOUS INJURY.SAVE THESE

4Know your pneumatic tool. Read operator’s manual carefully. Learn its applications and limitations, as well as the specific potential hazards

5SPECIFIC SAFETY RULESDuring normal use the tool will recoil immediately after driving a fastener. This is a normal function of the tool. Do

6SYMBOLSSome of the following symbols may be used on this tool. Please study them and learn their meaning. Proper interpreta-tion of these symbols wil

7GLOSSARY OF TERMSActivate (operating controls)To move an operating control so that it is in a position that allows the tool to be ac

8FEATURESFig. 1PRODUCT SPECIFICATIONSOperating Pressure .... 70-120 psiFastener Type ...

9FEATURESKNOW YOUR BRAD NAILERSee Figure 1.The safe use of this product requires an understanding of the information on the tool and in this operator’