RIDGID NaviTrack 10 Betreibershandbuch PDF herunterladen (Seite 21)

SeekTech

ST-510 Line Transmitter

Trouble Shooting Guide

PROBLEM PROBABLE FAULT LOCATION

Try powering the unit OFF and then back ON.

Adjust the LCD screen contrast.

Display appears

completely dark, or

completely light when

it is ON.

Allow the unit to cool if it has been exposed to excessive heat from sunlight.

Check that the correct frequency has been selected on both units. (See Control Menu for

the ST-510 receiver.)

Check to make sure that the receiver and the line transmitter are in the same mode and

on the same frequency. (See note on page 4 about using 93 kHz frequencies.)

Receiver will not pick

up the line trans-

mitter’s signal.

Make sure that the proper functions are activated on the receiver. e.g. activating the line

trace function for line tracing. (See manual for the particular receiver being used.)

Check orientation of batteries.

Check that the batteries are fresh or charged.

Unit will not power

ON.

Check to see that the battery contacts are OK.

Estimated Operating Times

Current Est. Time to Depletion

400 mA 1.8 hours

200 mA 3.6 hours

100 mA 7.25 hours

50 mA 14 hours

25 ma 28 hours

Standard Equipment

SeekTech ST-510 Transmitter

Direct connect leads and clips

Operator’s Manual

8 D-cell batteries (Alkaline)

Default settings for the transmitter:

60 Hz Mode

2 hr shutoff

30V-RMS Maximum

SeekTech frequencies loaded

Standard Replacement Parts

A. Direct Connect Lead (48ft./16m) (Cat#22758)

B. Battery Holder Cover Assembly (Cat#18428)

C. Battery Holder (Cat#18433)

D. Ground Spike (Cat#18438)

E. Direct Connect Lead Clip (Cat#18443)

F. Inductive Clamp (Optional) (Cat # 20973)

1 2 ... 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

RIDGID NaviTrack 10 Betreibershandbuch Seite 21

Kommentare zu diesen Handbüchern