RIDGID R843 Bedienungsanleitung PDF herunterladen (Seite 16)

OPERATION

Fig. 13

ANTI-SPLINTER

INSERT

PLUNGE CUTTING

See Figure 12.

WARNING:

To avoid loss of control, broken blades, or damage

to the material being cut, always use extreme

caution when making plunge cuts. We do not

recommend plunge cutting on materials other

than wood.

n Mark the line of cut clearly on the workpiece.

n Set the cutting angle at 0°.

n Tilt the saw forward so that it rests on the front edge

of the base and blade will not come in contact with the

workpiece when the saw is turned on.

n Make sure the blade is inside the area to be cut.

n Using high speed, start your saw and slowly lower the

blade into the workpiece until the blade cuts through the

wood.

n Continue lowering the blade into the workpiece until the

base rests flat on the work surface, then move the saw

forward to complete the opening.

n Use only the 7 teeth per inch blade for this type of cut.

SPLINTER-FREE CUTTING

See Figure 13.

This saw has an anti-splinter insert to permit splinter-free

cutting. It is especially useful when cutting plywood. This

feature should only be used when making straight cuts or

circle cuts. It is not for bevel cutting or plunge cutting.

NOTE: The non-orbital setting also helps reduce splintering

when cutting plywood.

n Remove the battery pack.

n Set the cutting angle at 0°.

n Attach the anti-splinter insert in the front of the base as

shown. Make sure it snaps securely into place.

n Replace the battery pack.

Fig. 12

1 2 ... 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

RIDGID R843 Bedienungsanleitung Seite 16